1.Voltage for 220V, Power Voltage will be in between 220V+10% and 220V-10%, low voltage will cause relay couldn’t liable connection, high voltage will cause the demage of ultrasonic generator.
2.ultrasonic cleaning tank’s temperature for 40degree, prohibiting no-water operation in cleaning tank, or else it will demage
mchine, attention!
3. the fun of ultrasonic generator is to provide heat elimination , so we should keep nomal operation and good intake of heat elimination
4. to put ultrasonic cleaner in dry place, non-corrosion’s environment, the temp is not exceeds 30 degree.
5. to draw out power when we dismantal machine.
6.It will automatically rising temperature after 10-15mins, if operator clean it in 70degree more, no suggestion,it is not higher than 45degree。
7.To Prohibit dismantle with electricity, to make sure all is safe for operator.
8.it could get Rubber’s odor when start to heat, it is nomal,it will disapper after several weeks.
1,電壓為220伏,功率電壓將在220 v±10%,低電壓將導致繼電器無法吸合,高電壓將導致超聲波清洗機損壞。
2,切忌!超聲波清洗槽無水狀態下嚴禁開機,以免損壞機器。
3,超聲波清洗器工作會產生一定的熱量,要保持機器散熱良好。
4,把超聲波放在清潔干燥的地方,非腐蝕的環境中,溫度不超過30度。
5,放/換清洗液時必須關斷電源。
6,清洗機連續工作10—15分鐘后會自動升溫,如用加溫方法清洗,則溫度不宜超過70℃,環境溫度不得高于45℃。
7,嚴禁帶電拆、裝清洗機,以防觸電!